John Deere 230LCR, 230LCRD — CHAPTER 15

TM 5-3805-280-10 Maintenance—Every 500 Hours REPLACE HYDRAULIC OIL FILTER 1. Park machine on a level surface. 2. Position machine with arm cylinder fully retracted and bucket cylinder fully extended. 3. Lower bucket to the ground. 4. Turn auto-idle switch off. IMPORTANT: Turbocharger may be damaged if engine is not properly shut down. 5. Run engine with engine rpm dial at 1/3 position without load for 2 minutes. 6. Move engine rpm dial to slow idle position. 7. Turn key switch to OFF. Remove key from switch. 8. Attach a Not Operate’ tag on the right control lever. 9. Pull pilot control shut-off lever to locked position. TX,80,DH5100 –19–08JUL96–1/4 CAUTION:

High pressure release of oil from pressurized system can cause serious burns or penetrating injury. The hydraulic tank is pressurized. Do not remove vent plug (A). Release pressure by loosening vent plug. 10. Loosen vent plug (A) to release hydraulic pressure. T7869AT –UN–12NOV92 Continued on next page TX,80,DH5100 –19–08JUL96–2/4 15-6