John Deere 230LCR, 230LCRD — CHAPTER 15

TM 5-3805-280-10 Maintenance—Every 500 Hours 11. Hold down filter cover (C) against light spring load when removing the last two cap screws. T7869AL –UN–12NOV92 TX,80,DH5100 –19–08JUL96–3/4 12. Remove spring (C), valve (E), and element (D). 13. Remove filter case and discard element and O-ring (F). CAUTION: Prevent possible injury from flying chips if compressed air is more than 210 kPa (2.1 bar) (30 psi). Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. NOTE:

Remove element and inspect for metal particles and debris in bottom of filter can. Excessive amounts of brass and steel particles can indicate a hydraulic pump, motor, or valve malfunction, or a malfunction in process. A rubber type of material can indicate cylinder packing problem. 14. Clean filter case with diesel fuel and dry with T6457ED –UN–18OCT88 compressed air. 15. Install filter case, valve (E), and spring (C) in reservoir. 16. Install cover (A) and tighten cap screws (B). Cover Cap Screw—Specification A—Cover B—Cap Screw C—Spring D—Element E—Valve F—O-Ring Torque 49 (36 lb-ft) ............................................................................. 17. Tighten vent plug.

TX,80,DH5100 –19–08JUL96–4/4 15-7