TM 5-3805-280-10 Maintenance—Every 1000 Hours FIRING ORDER 6—CYLINDER ENGINE: NOTE: Firing order is 1-5-3-6-2-4. 1. Adjust No. 1, 3, and 5 exhaust valves and No. 1, 2, and 4 intake valves. T6872AG –UN–18MAY94 Exhaust Valves (E)—Specification Clearance 0.46 mm (0.018 in.) ................................................................... Intake Valves (I)—Specification Clearance 0.36 mm (0.014 in.) ................................................................... A—No. 1 TDC Compression Stroke B—No. 1 TDC Exhaust Stroke C—Fan End of Engine 2. Rotate engine 360 ° and repeat step 1 for the remaining intake and exhaust valves. 3. Tighten jam nut to 27 (20 lb-ft). 4.
Clean cylinder head and rocker arm cover mating surfaces. 5. Install rocker arm cover gasket. Do not use sealant on the gasket. 6. Install rocker arm cover. Tighten screws to 35 (26 lb-ft). Do not over tighten cap screws. 7. Remove turning tool and timing pin. 8. Install parts. Center muffler to turbocharger inlet tube before fastening muffler into place. CED,OUOE042,28 –19–08MAR99–1/1 16-5