John Deere 230LCR, 230LCRD — CHAPTER 17

TM 5-3805-280-10 Maintenance—Every 2000 Hours DIESEL ENGINE COOLANT The engine cooling system is filled to provide year-round protection against corrosion and cylinder liner pitting, and winter freeze protection to -37 ° C (-34 ° F). ASTM D6211 (coolant concentrate) in a 40 to 60% mixture of concentrate with quality water Coolants meeting these specifications require use of supplemental coolant additives, formulated for heavy-duty diesel engines, for protection against corrosion and cylinder liner erosion and pitting. The following engine coolant is preferred for service: CID A-A-52624 Type 1 is a fully formulated ethylene glycol-based engine coolant concentrate.

CID A-A-52624 Type 1P is a prediluted (60% by vol. Glycol) fully formulated ethylene glycol-based engine coolant. CID A-A-52624 Type 11 is a fully formulated propylene glycol-based engine coolant concentrate. CID A-A-52624 Type 1 and Type 11 require dilution with water before use. CID A-A-52624 Type 1P is ready to use as packaged. John Deere PREDILUTED ANTIFREEZE/SUMMER COOLANT. John Deere COOL-GARD , where available. A 50% mixture of ethylene glycol engine coolant in water provides freeze protection to -37 ° C (-34 ° F). If protection at lower temperatures is required, consult your John Deere dealer for recommendations. Water quality is important to the performance of the cooling system.

Distilled, deionized, or demineralized water is recommended for mixing with ethylene glycol base engine coolant concentrate. IMPORTANT: Do not use cooling system sealing additives or antifreeze that contains sealing additives. John Deere ANTIFREEZE/SUMMER COOLANT CONCENTRATE in a 40 to 60% mixture of concentrate with quality water is also recommended. Coolant drain intervals Drain and flush the cooling system and refill with fresh coolant every 24 months. Other low silicate ethylene glycol base coolants for heavy-duty engines may be used if they meet one of the following specifications:

When John Deere PREDILUTED ANTIFREEZE/SUMMER COOLANT is used, the service interval may be extended to 36 months. ASTM D6210 (prediluted coolant) COOL-GARD is a trademark of Deere & Company. CED,OUOESLH,8 –19–09DEC99–1/1 17-2