John Deere 230LCR, 230LCRD — CHAPTER 17

TM 5-3805-280-10 Maintenance—Every 2000 Hours 13. Wrap threads of check plug and fill plug with sealing-type tape. Install plugs. Tighten plugs to 49 (36 lb-ft). 14. Change oil of second propel gearbox. TX,86,DH5152 –19–10AUG96–2/2 CHANGE HYDRAULIC OIL IMPORTANT: DO NOT run engine without oil in the tank. 1. Park machine on level surface with upperstructure rotated 90 ° for easier access. T6811AJ –UN–18OCT88 2. Position machine with arm cylinder fully retracted and bucket cylinder fully extended. 3. Lower bucket to the ground. 4. Turn auto-idle switch off. IMPORTANT: Turbocharger may be damaged if engine is not properly shut down. 5.

Run engine with engine RPM dial at 1/3 position without load for 2 minutes. 6. Move engine RPM dial to slow idle position. 7. Turn key switch to OFF to stop engine. Remove key from switch. 8. Pull pilot control shut-off lever to locked position. Continued on next page TX,OUOE042,29 –19–08MAR99–1/7 17-5