TM 5-3805-280-10 FASTENERS Visually check entire unit in regard to bolts, nuts and screws being properly secured. Spot check several capscrews and nuts for proper torque. If any are found loose, a more thorough inspection must be made. Take corrective action. SCAVENGE LINE High pressure air can cause severe injury or death from hot oil and flying parts. Always relieve pressure before removing caps, plugs, covers or other parts from pressurized air system. COMPRESSOR OIL Refer to Maintenance Schedule. RECEIVER-SEPARATOR SYSTEMS The scavenge line originates at the receiver- separator tank cover and terminates at the compressor airend through an orifice (.063 inch/1.6 mm).
Once a year or every 2000 hours of operation, whichever comes first, remove this line and any orifice, thoroughly clean, then reassemble. High pressure air can cause severe injury or relieve pressure before removing caps, plugs, death from hot oil and flying parts. Always covers or other parts from pressurized air NOTICE system. Excessive oil carry-over may be caused by an oil-logged separator element. Do not replace element without first performing the following maintenance procedure: * Open service valve at end of machine. * Ensure pressure is relieved, with BOTH: - Discharge air pressure gauge reads zero (0). 1. Check oil level. Maintain as indicated earlier in this section.
- No air discharging from service valve. 2. Thoroughly clean scavenge line, any orifice and check valve. * When draining oil, remove and replace (make tight) plug at bottom of separator tank. 3. Assure minimum pressure valve (if so equipped) has proper setting. * When adding oil, remove and replace (make tight) plug on side of separator tank. 4. Run unit at rated operating pressure for 30 to 40 minutes to permit element to clear itself. In the compressor lubricating and cooling system, separation of the oil from the compressed air takes place in the receiver-separator tank. As the compressed air enters the tank, the change in velocity and direction drop out most of the oil from the air.
COOLING FAN DRIVE The heat exchanger or cooling fan is driven by a multiple V-belt arrangement from the engine. Inspect the cooling fan belts weekly or at 50 hour intervals. These V-belts should be maintained at the proper tension. Fan belts that are too tight impose an undue load on the fan shaft bearings and shorten the life of the belts. Fan belts that are too loose allow slippage and lower the fan speed, cause excessive belt wear, and can lead to overheating of the cooling systems. Additional separation takes place in the oil separator element which is located in the top of the tank.
Any oil accumulation in this separator element is continuously drained off by means of a scavenge tube which returns the accumulated oil to the system. 18-6 WARNING WARNING