John Deere 230LCR, 230LCRD — CHAPTER 18

TM 5-3805-280-10 OIL SEPARATOR ELEMENT *Replace scavenge tube in cover (cover is still off of tank). The life of the oil separator element is dependent upon the operating environment (soot, dust, etc.) and should be replaced every twelve months or 2000 hours. To replace the element proceed as follows: *Measure from bottom of cover to end of scavenge tube (See Fig. 2). Measurement should be from 1/8” to 1/4” less than the * Ensure the tank pressure is zero. element measurement. If not, cut to size. *Remove scavenge tube. * Disconnect the hose from the scavenge tube. * Reposition cover (use care not to damage * Remove scavenge tube from tank cover. gaskets). *Replace cover mounting screws:

* Disconnect service line from cover. tighten in a crisscross pattern to 100 lbs.-ft. *Reconnect service line. Replace scavenge tube. * Remove (16) cover mounting screws. Reconnect hose. * Remove cover, element and inner shell. *Close service valve. Start unit and look for leaks. * Remove any gasket material left on cover or tank. * Install new gasket, inner shell and new element. When replacing the element, the scavenge lines, orifice, filter, and check valve should be thoroughly cleaned and the oil changed. *Place a straightedge across top of element and measure from bottom of straightedge to bottom of Note: Do not remove staples from the element (See Fig. 1). element/gasket connection.

Figure No. 1 Element Measurement Figure No. 2 Tube Measurement cut line if necessary 18-7