TM 5-3805-280-10 EXTERIOR FINISH CARE 7. Apply a smooth coat of Duponts 1854S Tuffcoat Primer to all bare metal areas and allow to dry. This unit was painted and heat cured at the factory with a high quality, thermoset polyester powder coating. The following care will ensure the longest possible life from this finish. 8. Apply 2 medium - wet coats of Duponts 222S Adhesion Promoter over the entire area to be painted, with a 5 minute flash in between coats. 1. If necessary to remove dust, pollen, etc. from housing, wash with water and soap or dish washing liquid detergent. Do not scrub with a rough cloth, pad, etc. 9. To apply the texture coat, use Duponts 1854S Tuffcoat Primer.
The proper technique to do this is to spray the Tuffcoat Primer using a pressure pot and use about 2-5 pounds of air pressure. This will allow the primer to splatter causing the textured look. Note: you must be careful not to put too much primer on at one time, this will effect the amount of texture that you are trying to achieve. Allow the texture coat to flash for 20 minutes or until dry to touch. 2. If grease removal is needed, a fast evaporating alcohol or chlorinated solvent can be used. Note: This may cause some dulling of the paint finish. 3. If the paint has faded or chalked, the use of a commercial grade, non- abrasive car wax may partially restore the color and gloss.
Field Repair of Texture Paint 10. Apply any of Duponts Topcoat Finishes such as Imron or Centari according to the label instructions. 1. The sheet metal should be washed and clean of foreign material and then thoroughly dried. Note: To re-topcoat the textured surfaces 2. Clean and remove all grease and wax from the area to be painted using Duponts 3900S Cleaner prior to sanding. when sheet metal repairs are not necessary, follow steps 1, 2, 4, 5, 6, 8 and 10. 3. Use 320 grit sanding paper to repair any scratches or defects necessary. Any unauthorized modification or failure to maintain this equipment may make it unsafe and out of factory warranty.
If performing more than visual inspections, disconnect battery cables and open manual blowdown valve. Use extreme care to avoid contacting hot surfaces (engine exhaust manifold and piping, air receiver and air discharge piping, etc.). Never operate this machine with any guards removed. 4. Scuff sand the entire area to be painted with a red scotch brite pad. 5. Wipe the area clean using Duponts 3900S. 6. Blow and tack the area to be painted. 18-8 CAUTION