John Deere 230LCR, 230LCRD — CHAPTER 19

TM 5-3805-280-10 Maintenance intervals DAILY EVERY 50 HOURS The CPA should be lowered in its rest position. Wash the machine. Check tightening of fixing cap bolts. Attachment to carrier Wipe all fittings before lubricating. Check the CPA attachment to the carrier boom end. Check all fixing pins are secured. Inspect all hoses. Replace if damaged. Pressurization air oiler The oiler is located on the side of the CPA cradle, close to the oscillation cylinder. Remove the oil fill plug (Pos. 1) to add oil. Drifter Front head lubrication Wipe the fitting before lubrication. Guide chains and ropes inspection – Examine the front chain in search of any signs of wear or corrosion. replace if required.

– Examine the whole length of the hose reel rope. In particular, check the attachment points on the tightener and the chain. The wire rope should not show signs of abnormal wear (flats on the outside strands, crushing, swelling or fraying). In any case, replace the cable immediately if : there are at least 2 broken wires at an inter- val of less than 36 mm (1.44 in) ( (6 times the nomi- nal diameter of the cable) or, there are at least 4 broken wires at an in- terval of less than 180 mm (7.2 in) (30 times the nominal diameter of the cable) or, if the cable diameter is inferior to 5,4 mm (.21 in) (nominal diameter of the cable less 10%).

Move the drifter at reduced speed until it reaches its front end position. – Examine the chain reel in search of any signs of wear or corrosion. Replace if required. 19-10