21-10 Operational Checkout PILOT CONTROLLER PATTERN CHECK (JOHN DEERE PATTERN) T102197 –UN–19JUL96 Left Control Lever T102198 –UN–19JUL96 Right Control Lever Engine at slow idle. Operate machine in clear area. Move pilot shut-off lever to UNLOCKED position. Slowly move hydraulic levers to all positions on decals. Do bucket, boom, arm, and swing move as decals show? NOTE: See John Deere control lever pattern in Operating the Machine chapter. YES: Go to next test. NO: Install decals for pattern (operator preference). Go to your authorized dealer. – – –1/1 (DYNAMIC) SWING BRAKE CHECK CAUTION: Make sure area is clear and large enough to swing extended bucket. Machine must be on level ground.
Position upperstructure with boom in front. Put boom, arm and bucket in fully extended position with bucket 900 mm (3 ft) above ground level. T6479AY –UN–19OCT88 Operate engine at fast idle. Actuate swing control valve to full stroke. Swing around 90 degrees and release lever. Does upperstructure stop within 45 degrees (1/8 turn) after releasing lever? Repeat procedure in opposite direction. YES: Go to next check. NO: Go to your authorized dealer. – – –1/1