21-11 Operational Checkout SWING CIRCUIT LEAKAGE CHECK Engine at slow idle. Position machine on a side hill or raise one side of machine 300 mm (1 ft) with the boom and ease block under track. Position bucket 300 mm (1 ft) off the ground at maximum reach. T6479AZ –UN–19OCT88 Bottom bucket cylinder and hold lever in the actuated position. NOTE: Actuating the bucket function releases the mechanical swing brake. Does upperstructure move only slightly? YES: Go to next check. NO: Go to your authorized dealer. – – –1/1 DIG FUNCTION DRIFT CHECK Engine at slow idle. Fill bucket with dirt and position bucket at maximum reach with bucket 2 in. (50 mm) above ground. Observe bucket for 1 minute.
Does bucket drift down to ground within 1 minute? T6290AF –UN–19OCT88 YES: Go to your authorized dealer. NO: Go to next check. – – –1/1 CONTROL VALVE LIFT CHECK TEST Engine at slow idle. Position machine as illustrated. Slowly actuate pilot controller to lower boom, extend arm (retract cylinder), and dump bucket (retract cylinder). Do functions move in opposite direction as control levers are moved, then change direction as levers are moved T6292AZ –UN–19OCT88 further? YES: If functions move in opposite direction first, a leak within the cylinder or lift check valve is indicated. Go to your authorized dealer. NO: Go to next check. – – –1/1