Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION WORK EQUIPMENT • SWING PPC VALVE 3. During fine control (when control lever is re- turned) a. When disc (5) starts to be returned, spool (1) is pushed up by the force of centering spring (3) and the pressure at port P1 . When this happens, fine control hole f is connected to drai chamber D and the pres- surized oil at port P1 is released. b. If the pressure at port P1 drops too far, spool (1) is pushed down by metering spring (2), and fine control hole f is shut off from drain chamber D .

At almost the same time, it is connected to pump pressure chamber PP , and the pump pressure is supplied until the pressure at port P1 re- covers to a pressure that corresponds to the lever position. c. When the spool of the control valve re- turns, oil in drain chamber D flows in from fine control hole f in the valve on the side that is not working. The oil passes through port P2 and enters chamber B to fill the chamber with oil. 4. At full stroke a. When disc (5) pushes down piston (4), and retainer (9) pushes down spool (1), fine control hole f is shut off from drain cham- ber D , and is connected with pump pres- sure chamber PP .

Therefore, the pilot pres- sure oil from the main passes through fine control hole f and flows to chamber A from port P1 , and pushes the control valve spool. b. The oil returning from chamber B passes from port P2 through fine controle hole f and flows to drai chamber D . 10-110