STRUCTURE AND FUNCTION ELECTRONIC CONTROL SYSTEM 9. Components of system 1) Engine speed sensor 1. Wire 2. Magnet 3. Terminal 4. Housing 5. Connector Function The engine speed sensor is installed to the ring gear portion of the engine flywheel. It counts electrically the number of gear teeth that pass in front of the sensor, and sends the results to the engine throttle • pump controller. This detection is carried out by a magnet, and an electric current is generated every time the gear tooth passes in front of the magnet. 2) PPC hydraulic switch 1. Plug 2. Switch 3. Connector Specifications Composition of points : N.O. points Actuation (ON) pressure :
0.49 ± 0.1 MPa 5.0± 1.0 kg/cm 2 Reset (OFF) pressure: : 0.29 ± 0.05 MPa 3.0± 0.5 kg/cm 2 Function There are switches installed to the junction box. The operating condition of each actuator is detected from the PPC pressure, and this is sent to the engine throttle • pump controller. 10-160