ELECTRONIC CONTROL SYSTEM STRUCTURE AND FUNCTION Pump pressure sensor 1. Sensor 2. Connector Structure off circuit Function Two sensors are mounted in each actuator cir- cuit of the boom and arm (four sensors in all). The load pressure on the actuator is converted to the voltage and sent to the controller. Operation 1. When the oil entering from the pressure inlet applies pressure to the diaphragm of the oil pressure detector, the diaphragm of the oil pressure detector, the diaphragm is deflected and deformed. 2.
A gauge layer is mounted at the opposite side of the diaphragm and the resistance value of the gauge converts the deflection of the dia- phragm into the output voltage and sends it to the amplifier (voltage amplifier). 3. The amplifier sends the signal to the governor and pump controller. 4. The relational expression of the pressure P (MPa (kg/cm 2 ) and the output voltage V: V = 0.008 X P + 1.0 10-161