TESTING AND ADJUSTING TESTING AND ADJUSTING HYDRAULIC PRESSUREIN WORK EQUIPMENT, SWING AND TRAVEL CIRCUIT c. Measuring pump relief pressure i. Low setting (oil pressure: 31.9 MPa (325 kg/cm 2 )) (1) Measure the pressure when each actuator except the travel actuator is relieved in H/O mode with the engine at full throttle. # Note that the set pressure of the safety valve for the swing motor and head end of the boom is lower than the main relief low set pressure, so the value meas- ured will be the relief pressure will rise, so always keep the lock switch OFF when measuring. # When measuring the swing relief pressure, measure with the swing lock turned switch ON. ii.
High setting (oil pressure: 34.8 MPa (355 kg/cm 2 ) (1) When travel is operated. Measure the oil pressure when the travel is relieved on each side separately in H/O mode with the engine at full throttle. # To relieve the travel circuit, put block 1 under the track shoe grouser, or put block 2 between the sprocket and frame to lock the track. (2) When power max. function is actuated. When measuring the oil pressure in G/O or H/O mode with the engine at full throttle and the power max. function actuated, relieve one of the boom, arm, or bucket circuits, and measure the oil pressure. 20-35