TESTING AND ADJUSTING MEASURE OIL LEAKAGE # 1. # 20-53 ASURE OIL LEAKAGE Oil temperature when measuring: 45 – 55°C Work equipment cylinder If the hydraulic drift of the work equipment is outside the standard value, measure the leakage inside the cylinder as follows, and judge if the cause of the hy- draulic drift is in the cylinder or in the control valve. If the leakage is within the standard value, the prob- lem is in the control valve. If the leakage is within the standard value, the prob- lem is in the cylinder. a. Fully extend the rod of the cylinder to be meas- ured, then stop the engine. b.
Disconnect piping (1) at the head end, then block the piping at the chassis end with a blind plug. Be careful not to disconnect the piping at the bottom end. c. Start the engine and apply the relief pressure to the bottom end of the cylinder with the engine at high idling. d. Continue this condition for 30 seconds, then measure the oil leakage for one minute.