TESTING AND ADJUSTING BLEEDING AIR BLEEDING AIR Order for operation and procedure for bleeding air Note 1: Bleed the air from the swing and travel motors only when the oil inside the motor case has been drained. 1. Bleeding air from the pump a. Loosen air bleed plug (1), and check that oil oozes out from the plug. b. When oil oozes out, tighten plug (1). Plug: 17.15 ± 2.45 Nm (1.75 ± 0.25 kgm) # If no oil oozes out from the air bleed plug: c. Leave plug (1) loosened and remove hose (2) and elbow (3). d. Pour in oil through the elbow mount hole until oil oozes out from plug (1). e. Fit elbow (3) and install hose (2). f. Tighten air bleed plug (1).
BP00800 a - b Rear and front pump discharge pressure rest points c Pump bleed point d Servo piston input pressure test point of rear pump Plug: 17.15 ± 2.45 Nm (1.75 ± 0.25 kgm) # Precautions when starting the engine. After complet- ing the above procedure and starting the engine, run the engine at low idling for 10 minutes. # If the coolant temperature is low and automatic warm- ing-up is carried out, cancel it by using the fuel control dial after starting the engine.
20-57 Air bleeding item Nature of work Air bleeding procedure 1 2 3 4 5 6 Bleeding air from pump Start engine Bleeding air from cylinder Bleeding air from swing motor Bleeding air from travel motor Start opera- tions Replace hydraulic oil Clean strainer O O O O Note 1 O Note 1 O Replace return filter element O O O Replace, repair pump Remove suction piping O O O O Replace, repair control valve O O O Replace cylinder Remove cylinder piping O O O Replace swing motor Remove swing motor piping O O O Replace travel motor, swivel Remove travel motor, swivel piping O O