Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE c. Action to take after removing connectors i. After removing any connector, cover it with a vinyl bag to prevent any dust, dirt, oil or water from getting in the connector portion. # If the machine is left disassembled for a long time, it is particularly easy for improper contact to occur, so al- ways cover the connector. d. Connecting connectors i. Check the connector visually ii. Check that there is no oil, dirt, or water stuck to the connector pins (mating portion). iii. Check that there are no deformation, defec- tive contact, corrosion, or damage to the con- nector pins. iv.

Check that there is no damage or breakage to the outside of the connector. # If there is any oil, water, or dirt stuck to the connector, wipe it off with a dry cloth. If any water has got inside the connector, warm the inside of the wiring with a dryer, but be careful not to make it too hot as this will cause short circuits. # If there is any damage or breakage, replace the con- nector. v. Fix the connector securely vi. Align the position of the connector correctly, then insert it securely. vii. For connectors with lock stopper, push in the connector until the stopper clicks into posi- tion. viii. Correct any protrusion of the boot and any misalignment of the wiring harness. ix.

For connectors fitted with boots, correct any protrusion of the boot. In addition, if the wiring harness is misaligned, or the clamp is out of position, adjust it to its correct position. # If the connector cannot be corrected easily, remove the clamp and adjust the position. x. If the connector clamp has been removed, be sure to return it to its original position. Check also that there are not loose clamps. 20-63