TROUBLESHOOTING DISPLAY METHOD AND SPECIAL FUNCTIONS OF MONITOR PANEL Operation Display 4. To finish with the trouble data display mode, keep the TIME switch + L.H. travel speed switch pressed for 2.5 sec- onds. 5. To erase the memory, keep the time switch pressed, turn the starting switch from OFF to ON, and keep the time switch pressed for 5 seconds. 3) If there is no abnormality code in memory 3. Machine data monitoring function The input signals from the sensors and the output signals to drive the solenoid are displayed on the time display and service meter display. a. Method of displaying monitoring code 20-85 Operation 1. To set to the machine data monitoring mode, do as follows.
Keep the time switch + knob button func- tion switch pressed for 2.5 seconds. Note:This is possible at the following times. 1) During the normal mode 2) During the user code display mode 3) During the time adjustment mode 4) During the trouble data display mode 1. On the time display and service meter display, the moni- toring code and data are displayed. • Example of display 1) When engine speed is monitored (monitoring code 10)