Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING E-MODE 20-108 Condition when normal (voltage, current, resistance) Action by controller when abnormality is detected Problem that appears on machine when there is abnormality C03 E04 Resistance (female) (male) value (7)-(14) (1)-(2) 0.25-7kq (7)-(17) (2)-(3) 0.25-7kq (14)-(17) - 2-3kq - (1)-(3) 4-6kq Between eachpin - NMoi nco.n1tinMuqity andchassis Calculates position of motor and carries out control from value of voltage immediately before abnormality occurred 1. Precision of engine speed con- trol may be reduced. For example:

1) Engine does not rise to high idling speed (a little too low) 2) Engine does not go down to low idling speed (a little too high) 3) Defective engine speed for autodeceleration or auto- matic warming-up 4) Engine may not stop # The governor motor mo- ves in the direction to stop the engine, but the motor may not move completely to the position to stop the engine. 5) There are cases of hunting Between C03 (1) and chassis: 20 - 30 V # Holds with the motor in the stop position for 2 - 2.5 sec, returns to the low idling position, the turns the battery relay OFF. Sets battery relay drive cur- rent to 0 Engine does not stop 1. Linkage adjustment correct 1.

Displays when returning from high idling to low idling # Starts again (repeats step-out) 2. In some cases it may not display when returning from partial speed to low idling Engine speed cannot be controlled (particularly at high idling), so there is hunting 2. Must move lightly when connector is removed 3. Normal C03 (female) E04 (male) Resistance value (7)-(14) (1)-(2) 0.25-7kq (7)-(17) (2)-(3) 0.25-7kq (14)-(17) - 2-3kq - (1)-(3) 4-6kq Between eachpin andchassis - NMoi nco.n1tinMuqity