TROUBLESHOOTING E-MODE E-1 Abnormality in engine throttle • pump controller power source (controller LED is OFF) # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # Check that fuse 1 is not blown. # Before carrying out troubleshooting, check that all related connectors are properly inserted. # Always connect any disconnected connectors before going on to the next step. # When the starting motor rotates correctly.
(If the starting motor also does not rotate, go to E-8.) E-1 Related electric circuit diagram 20-113 YES 1 Is voltage between C01 (7) (6) and between C01 (12) 2 YES normal? Is voltage between fuse 1 and chassis • Turn starting switch NO normal? ON. • 20 - 30 V • Turn starting switch NO ON. • 20 - 30 V Cause Remedy Defective governor, pump controller Defective contact, or disconnection in wiring harness between fuse 1 and C01 (female) (7) (13) Defective contact, or disconnection in wiring harness between fuse 1- H15 (2)-M14 (2) (1)-battery relay M Replace Repair or replace Repair or replace