Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING E-MODE E-2 [E308] Abnormality in fuel control dial input value is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # Before carrying out troubleshooting, check that all the related # If E306 also occurs at the same time, check the wiring harness between C03 (female) (7) - E04 (female) (1) short circuiting with ground or contact with other parts of the wiring harness.

Table 1 E-2 Related electric circuit diagram Engine throttle, pump controller 20-114 connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. 2 YES Is resistance between each YES pin of C03 (female) (4) (7) (17), or between each pin 1 and chassis as shown in Table 1? Is resistance between E06 (male) • Turn starting switch NO (1)-(2), (2)-(3) as OFF. show in Table 1? • Disconnect C03. • Turn starting switch OFF.

NO • Disconnect E06 Cause Remedy Defective engine throttle, pump controller Defective wiring harness in system with defective resistance Defective fuel control dial Replace Replace Replace C03(female) E04(male) Resistance value (7)-(4) (1)-(2) 0.25-7kq (4)-(17) (2)-(3) 0.25-7kq (7)-(17) - 2-3kq - (1)-(3) 4-6kq Betweeneach pinandchassis - NMoi nco.n1tinMuiqty