TROUBLESHOOTING C-MODE C-14 [E217] Model selection input error is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if an E service code is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check if an E service code is displayed. (If it is not displayed, the problem had been removed). # Before carrying out troubleshooting, check that all related connectors are properly inserted.
# Always connect any disconnected connectors before going on the next step. Table 1 Monitoring code display # The diagram shows monitoring code 03. # Check the bit pattern display marked with r . Table 2 Voltage of wiring harness 20-186 YES 1 Is monitoring mode display as shown in Table 1? 2 YES Is voltage between • Turn starting switch C17 (5) (6) (7) (13) ON. NO (14) and chassis as • Set to monitoring shown in Table 2? codes [02, 03 and [21,22]. • Turn starting switch NO ON.
Cause Remedy Defective engine throttle - pump controller Defective model selection connector, or disconnection, short circuit with ground, or short circuit in witing harness wh4ere voltage is defective Replace Repair or replace Modelcodedisplay Modelselectionsignalinputdisplay Monitoringcodes02,03 Monitoringcode21 Monitoringcode22 C17 Between(5)-chassis Between(6)-chassis Between(7)-chassis Between(13)-chassis Between(14)-chassis Voltage Max.1V Max.1V 20-30V Max.1V 20-30V