TROUBLESHOOTING H-MODE H-10 Work equipment (boom, arm, bucket) does not move (but travel and swing are normal) H-11 Excessive hydraulic drift (boom, arm, bucket) 2) Excessive hydraulic drift of arm or bucket 20-222 # When boom, arm, and bucket are each operated independently. 1 YES Is output pressure of PPC valve normal? • Min. 2.7 MPa NO (28 kg/cm2) • Engine at high idling Cause Remedy Defective control valve spool Defective PPC valve Rreplace Correct or replace 1) Excessive hydraulic drift of boom 1 YES Does speed of downward movement become faster when lever is operated? 2 YES • SeeTESTING AND Does condition ADJUSTING.
become normal when • It is also possible to NO satety-suction valve measure leakage of is interchanged? cylinder. • Max. 20 cc/min NO • At relief and ngine at high idling Cause Remedy Defective hydraulic cylinder piston packing Defective operation of satety-suction valve Defective operation of boom lock valve Replace Replace Correct or replace Note 1: After inspection, do not forget to return the interchanged valves to the original position. YES 1 Does speed of downward movement YES become faster when lever is operated? 2 Does condition • See TESTING AND become normal when ADJUSTING. NO safetysuction valve is 3 YES • It is also possible to interchanged?
measure leakage of Is slipper seal of pres- sure compensation val- cylinder. ve damaged? Or does • Max. 20 cc/min NO pressure compensation • At relief and engine piston move smoothly? at high idling • It is also possible to NO interchange with other compensation valve. • See Note 1. Cause Remedy Defective hydraulic cylinder piston packing Defective operation of safety-suction valve Defective control valve spool Damaged slipper seal of pressure compensation valve, or defective operation of pressure compensation piston Replace Replace Replace Correct or replace