Komatsu — eebm001902 a3.pdf

TROUBLESHOOTING M-CODE M-8 When starting switch is turned ON (engine stopped), basic check items flashes # Before carrying out troubleshoting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. a) (coolant level) flashes # Check that the coolant is at the specified level before carrying out troubleshooting. Table 1 M-9 a) Related electric circuit diagram Engine throttle, pump controller 20-251 YES 4YES YES Is bit (3) of 1 monitoring code 24 3 lighted up? Does display go out Is continuity between when short connec- YES C16 (female) (8) and • Turn starting switch NO tor is connected to chassis as shown in ON.

P08 (female)? table? • Set to monitoring • Disconnect P08. code 24. 2 • Turn starting switch • Turn starting ON. Is there continuity switch OFF. NO between P08 • Disconnect C16, P08. (female) (2) and • Connect disconnect short NO chassis? connector to P08 (female). NO • Turn starting switch OFF. • Disconnect P08.

Cause Remedy Defective coolant level sensor system (See M-26) Defective engine throttle - pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between C16 (female) (8) - P08 (female) (1) Defective contact, or disconnection in wiring harness between P08 (female) (2) - chassis ground - Replace Replace Repair or replace Repair or replace Short connector Continuity Connected Yes Disconnected No