TROUBLESHOOTING M-CODE M-18, 19 Related electric circuit diagram Engine throttle, pump controller M-20 Swing lock switch is turned ON (LOCK) but (swing lock monitor) does not light up # Carry out this troubleshooting only if the swing lock is actually being actuated. # Before carrying out troubleshooting, check that all the related # the next step. 1 Is voltage between P05 and chassis as shown in table? Turn starting switch ON. M-20 Related electric circuit diagram Table 20-266 are properly inserted. ect any disconnected connectors before going on p.
YES Cause Remedy Defective monitor panel Defective contact or disconnection in wiring harness between P01 (female) (5) - X01 (4) - X05 (male) Replace Repair or replace NO SwinglockswitchON Max.1V SwinglockswitchOFF 20-30 V