TROUBLESHOOTING M-CODE M-26 Defective engine oil sensor system # Remove the engine oil level sensor when carrying out troubleshooting. Note 1: Variations in oil level. The oil level may change according to the angle of the machine, the engine speed, or the temperature of the oil, so if there is any display, check the oil level again with the machine at a horizontal place. Note 2: If the problem occurs again, the connector (female) at the chassis end is probably defective, so check the connector and wiring harness at the chassis end. Note 3: Check for vibration at the connector mount. If there is excessive vibration, take the appropriate action. Note 4:
Defective installation is a possible cause, so be careful when installing. If the problem occurs again, check for any vibration of the mount, and if there is excessive vibration, take the appropriate action. 20-271 YES 2 Is any foreign YES material (dirt) stuck to moving part of 3 YES float? Is there any large 1 crack, chip or When float is moved up NO damage to float? and down, is resistance between connector (1) NO and flange as shown in Table 1? 4 YES Check wiring harness visually. NO Is it broken?
NO Table Cause Remedy Defective movement of float due to dirt Resonance of mount (See Note 2) Defective contact of connector (See Note 2) Disconnection in wiring harness (Se Note 3) (defective clamp) (external force applied) Defective sensor Clean Replace sensor (See Note 4) Clean connector or replace Replace sensor Replace FloatUP Max.1q FloatDOWN Min.1 Mq