STRUCTURE AND FUNCTION HYDRAULIC PUMP Operation LS valve 1. When the control valve is at a neutral position a. The LS valve is a three-way selector valve, with pressure PLS (LS pressure) from the inlet port of the control valve brought to spring chamber B , and main pump dis- charge pressure PP brought to port H of sleeve (8). The size of PLS + force Z of spring (4) and the main pump pressure (self pressure) PP determines the position of spool (6). However, the size of the out- put pressure PSIG of the EPC valve for the LS valve entering port G also changes the position of spool (6). (The set pressure of the spring changes.) b.
Before the engine is starting, servo piston (11) is pushed to the right. (See the dia- gram on the right). c. When the engine is started and the control lever is at the neutral position, LS pressure PLS is 0 MPa. (It is interconnected with the drain circuit through the control valve spool.) At this point, spool (6) is pushed to the left, and port C and port D are con- nected. Pump pressure PP enters the large diameter end of the piston from port K , and the same pump pressure PP also enters port J at the small diameter end of the piston, so the swash plate is moved to the minimum angle by the difference in area of piston (11). 10-26