STRUCTURE AND FUNCTION HYDRAULIC PUMP ii. Action of spring (1) The spring load of springs (4) and (6) in the PC valve is determined by the swash plate position. (2) When servo piston (9) moves, piston (7), which is connected to slider (8), also moves to the left or right. (3) If piston (7) moves to the left, spring (6) is compressed, and if it moves further to the left, spring (6) contacts seat (5) and is fixed in position. In other words, the spring load is changed by piston (5) extending or compressing springs (4) and (6).
(4) If the command current input to PC-EPC valve solenoid (1) changes further, the force pushing piston (2) changes, and the spring load of springs (4) and (6) also changes according to the value of the PC-EPC valve solenoid command current. (5) Port C of the PC valve is connected to port E of the LS valve (see LS valve). Self pressure PP1 enters port B and the small diameter end of servo piston (9), and other pump pressure PP2 enters port A . (6) When pump pressures PP1 and PP2 are small, spool (3) is on the left. At this point, port C and D are connected, and the pressure entering the LS valve becomes drain pressure PT .
If port E and G of the LS valve are connected (see LS valve), the pressure entering the large diameter end of the piston from port J becomes drain pressure PT , and servo piston (9) moves to the right. In this way, the pump discharge amount moves in the direction of increase. (7) As servo piston (9) moves further, piston (7) is moved to the left by slider (8). Springs (4) and (6) expand and the spring force becomes weaker. When the spring force becomes weaker, spool (3) moves to the right, so the connection between port C and D is cut, and the pump discharge pressure ports B and C are connected.
As a result, the pressure at port C rises, and the pressure at the large diameter end of the piston also rises, so the movement of piston (9) to the right is stopped. In other words, the stop position for piston (9) (= pump discharge amount) is decided at the point where the force of springs (4) and (6) and the pushing force from the PC-EPC valve solenoid and the pushing force created by pressures PP1 and PP2 acting on spool (3) are in balance. 10-31