STRUCTURE AND FUNCTION HYDRAULIC PUMP b. When load on actuator is large and pump discharge pressure is high. i. When the load is large and pump discharge pressure PP1 and PP2 are high, the force pushing spool (3) to the left becomes larger and spool (3) moves to the position shown in the diagram above. When this happens, as shown in the diagram above, part of the pressurized oil from port A flows out through the LS valve from port C to port D and the pressurized oil flowing from port C to the LS valve becomes approximately half of main pump pressure PP . ii.
When port E and G of the LS valve are connected (see LS valve), the pressure from port J enters the large diameter end of servo piston (9), and servo piston (9) stops. iii. If main pump pressure PP increases further and spool (3) moves further to the left, main pump pressure PP1 flows to port C and acts to make the discharge amount the minimum. When piston (9) moves to the left, piston (7) is moved to the left. For this reason, springs (4) and (6) are compressed and push back spool (3). When spool (3) moves to the left, the opening of port C and D becomes larger. As a result, the pressure at port C (= J ) drops, and piston (9) stops moving to the left.
The position in which piston (9) stops when this happens is further to the left than the position when pump pressure PP1 and PP2 are low. 10-32