Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY TRACK ROLLER ASSEMBLY OF TRACK ROLLER ASSEMBLY 1. Using push tool a , press fit bushings (9) and (10) to roller (4). 2. Assemble collar (8) to shaft (5), and install pin (7). 3. Using tool M1 , install floating seal (6) to shaft (5). # When assembling the floating seal, clean the contact surface of 0-ring (6c) and floating seal (6a), remove all grease and oil, and dry it. Make sure that no dirt or dust sticks to the contact sur- face of the floating seal. # After inserting the floating seal, check that the angle of the seal is less than 1 mm and that the protrusion of the seal is within a range of 5 - 7 mm. 4.

Using tool M1 , install floating seals (6) and (3) to roller (4). # For details of the precautions when installing floating seals (6b) and (6d), and (3b) and (3d), see the precautions marked # for Step 3. 5. Assemble shaft (5) to roller (4). 6. Turn over roller (4) and shaft (5) assembly. 7. Using tool M1 , install floating seal (3) to collar (2). # For details of the precautions when installing floating seals (3a) and (3c), see the precautions marked # for Step 3. 30-75