DISASSEMBLY AND ASSEMBLY CARRIER ROLLER ASSEMBLY OF CARRIER ROLLER ASSEMBLY 1. Using push tool e , press fit outer races (8) and (9) to roller (6). 2. Assembly of shaft assembly. 1) Using tool L3 , press fit collar (12) to shaft (13). # When press fitting, be careful that there is no scuffing. Fitting portion of shaft: Engine oil (E030-CD) 2) Using tool L2 , assemble floating seals (11). # When assembling the floating seal, clean the contact surface of 0-ring (lic) and floating seal (ha), remove all grease and oil, and dry it. Make sure that no dirt or dust sticks to the contact surface of the floating seal.
# After inserting the floating seal, check that the angle of the seal is less than 1 mm and that the protrusion of the seal is within a range of 5 - 7 mm. 3) Assemble floating seals (11), then using push tool f , press fit inner race (10). # For details of the precautions when installing floating seals (1 lb) and (lid), see the precau- tions marked # for Step 2). 3. Assemble roller (6) to shaft assembly (5). 4. Using push tool 07, press fit inner race (7). # When press fitting the bearing, rotate the roller, and press fit to a point where the rota- tion becomes slightly heavier. 5. Using tool L1 tighten nut (4) to a point where drill hole in shaft is aligned with drill hole in nut. 30-80