DISASSEMBLY AND ASSEMBLY PC VALVE PC VALVE Removal Disconnect the cable from the negative (-) terminal of the battery. Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Remove the hydraulic tank strainer, and using tool B , stop the oil. When not using tool B , remove the drain plug, and drain the oil from the hydraulic tank and inside the sys- tem. Hydraulic tank: Approx. 170 l. There are PC valve assemblies installed to both the front pump and the rear pump, but the procedure for removal is the same. 1. Remove nut (1), then remove hose assembly (2). 2.
Install locknut a 01582-11008 1 Locknut: 100.5 ± 12.5 Nm (10.25 ± 1.25 kgm) 3. Turn nut (3) in direction of loosening, then tighten at locknut a end. # Angle of turning for nut (3): Approximately 30° 4. Fit tool to width across flats (22 mm) of hexagonal por- tion of sleeve (4), then loosen and remove PC valve assembly (5). 2 3 Installation Carry out installation in the reverse order to removal. 1 Nut (2): 100.5 ± 12.5 Nm (10.25 ± 1.25 kgm) # After installing the PC valve assembly, remove locknut a . 2 3 # Adjust the PC valve assembly. For details, see TEST- ING AND ADJUSTING, testing and adjusting PC valve output pressure (servo piston inlet pressure). Nut (3):
100.5 ± 12.5 Nm (10.25 ± 1.25 kgm) Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. 30-100