DISASSEMBLY AND ASSEMBLY MAIN RELIEF VALVE MAIN RELIEF VALVE Disassembly 1. Loosen locknut (9), remove plug (8), then remove re- tainer (6). 2. Loosen locknut (10), then remove holder (7), spring (11), seat (12), and poppet (5). 3. Remove ring (1), then remove valve (3) and spring (4). # If any abnormality is found in any part after disassem- bly, replace the whole main relief valve assembly. Assembly Coat the sliding surfaces with engine oil. 1. Assemble spring (4) and valve (3), then install ring (1). 2. Install seat (12), poppet (5), spring (11), and holder (7), and secure in position with locknut (10). Locknut: 53.9 ± 4.9 Nm (5.5 ± 0.5 kgm) 3.
Fit retainer (6), then install plug (8) and secure in posi- tion with locknut (9). Locknut: 39.7 ± 4.9 Nm (4.0 ± 0.5 kgm) # After installing main relief valve to control valve as- sembly, adjust pressure referring to TESTING AND ADJUSTING, testing and adjusting hydraulic pressure in work equipment, swing, travel circuit. 1 2 30-99