Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY TRAVEL PPC VALVE Disassembly 1. Remove screws (1), then remove levers (2). 2. Remove mounting bolts (3), then remove case and shaft assembly (4). 3. Remove mounting bolts (5), then remove plate (6) and damper assembly (7) as one unit. # Check the thickness and mounting position of washer (18). # Never disassemble damper assembly (7). 4. Remove mounting bolts (8), then remove damper as- sembly (7) from plate (6). 5. Remove seal (9) and collar (10). 6. Pull out piston (11), and remove retainer (12), springs (13) and (14), and shims (15). # Check the number and thickness of shims (15) for each mounting position and keep in a safe place. 7.

Pull out valve (16) from body (17). Installation 1. Assemble valve (16) in body (17). 2. Assemble shim (15) and spring (14) to valve (16). # Assemble the same number and thickness of shim (15) as was removed during disassembly. Standard shim thickness: 0.3 mm. # Spring (14) is not symmetrical at the top and bottom, so assemble with the small coil diameter (inside diam- eter) at the shim end. 3. Assemble spring (13), retainer (12), and piston (11). Outside circumference of piston, body hole: Grease (G2-L1). 4. Fit O-ring to collar (10) and assemble in body (17), then install seal (9). 5. Install damper assembly (7) to plate (6), then tighten mounting bolts (8). Mounting bolt:

Thread tightener (LT-2) Mounting bolt: 4.41 ± 0.49 Nm (0.45 ± 0.05 kgm) 6. Install plate (6) and damper assembly (7) as one unit, then tighten mounting bolts (5). # Check the thickness of washer (18) and assemble in the position checked during disassembly. Mounting bolt: 30.87 ± 3.43 Nm (3.15 ± 0.35 kgm) 7. Install case and shaft assembly (4), then tighten mounting bolts (3). # Check that the out-of-parallel of shaft and damper as- sembly (7) of case and shaft assembly (4) is less then 0.5. Rocking portion of shaft, connection of lever and piston: Grease (G2-L1) Mounting bolt: 27.93 ± 3.43 Nm (2.85 ± 0.35 kgm) 8. Install levers (2), then tighten screws (1).

# Adjust so that lever (2) can slightly move. Rocking portion of lever pin and plate: Grease (G2-L1). Screw: 8.82 ± 0.98 Nm (0.9 ± 0.1 kgm) 30-108