Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY BOOM CYLINDER REMOVAL OF BOOM CYLINDER ASSEMBLY Extend the arm and bucket fully, lower the work equip- ment completely to the ground, and put the safety lock lever in the LOCK position. 1. Disconnect grease hose (1). 2. Sling boom cylinder assembly (2), and remove lock bolt (3). 1 3. Remove plate, then remove head pin (4). # There are shims installed, so check the number and thickness, and keep in a safe place. 2 4. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. # Set stand a under the cylinder assembly, and adjust the position for slinging. Release the remaining pressure in the hydraulic circuit.

For details, see TESTING AND ADJUST- ING, Releasing remaining pressure in hydraulic circuit. 5. Disconnect hoses (5). 6. Remove plate, then using forcing screws b , remove bottom pin (6), and remove boom cylinder assembly (2). # There are shims installed, so check the number and thickness, and keep in a safe place. 3 Boom cylinder assembly: 250 kg 30-109