DISASSEMBLY AND ASSEMBLY ARM ARM Removal 1. Remove bucket assembly. For details, see BUCKET, Removal. 2. Secure front link to arm with wire. 3. Pull in arm so that it is easy to remove pin at arm cyl- inder head, then lower arm and bucket cylinder as- sembly (1) on to block a . Set the safety lock lever to the LOCK position. 4. Set block b between arm cylinder and boom. 5. Remove plate, then remove arm cylinder head pin.(2) 6. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. 1 Release the remaining pressure in the hydraulic cir- cuit. For details, see TESTING AND ADJUSTING, Releasing remaining pressure in hydraulic circuit. 7.
Disconnect 2 hoses (3) and 2 hoses (4). # Install blind plugs at the male end and in the discon- nected hoses. # Hoses (4) are for machines equipped with an addi- tional attachment circuit. 8. Remove plate, then remove connecting pin (5) be- tween arm and boom. # There are shims installed, so check the number and thickness, and keep in a safe place. 9. After raising boom, swing to remove arm and bucket cylinder assembly (1). 2 Arm, bucket cylinder assembly: 1330 kg 30-125