Komatsu — eebm001902 a3.pdf

DISASSEMBLY AND ASSEMBLY BUCKET Installation Carry out installation in the reverse order to removal. 1 3 # When tightening the locknut, tighten so that the clear- ance between the plate and nut is 0.5 - 1.5 mm. 2 Inside surface of bushing when assembling pin: anti-friction compound (LM-P) Greasing after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance be- tween bucket boss (7) and link (8 ) is below 1 mm. # Standard shim thickness: 0.8 mm, 1.5 mm. 4 Inside surface of bushing when assembling pin: anti-friction compound (LM-P) Greasing after assembling pin:

Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Set the O-ring at the end face of the bucket boss se- curely. # Adjust the shim thickness so that the clearance be- tween arm top (9) and spacer (10) is 0.5- 1.0 mm. # Standard shim thickness: 0.5 mm, 1.0 mm. 30-124