STRUCTURE AND FUNCTION CLSS LS select valve # The diagram shows the situation when the swing, the left travel and the boom up are operated at the same time. ( BP pressure ON = boom up activated) 1. Valve 2. Spring 3. Piston 4. Piston 5. Swing pool 6. L.H. travel spool 7. Arm spool 8. L.H. shuttle valve 9. LS circuit Function This valve is used to increase the ease of oper- ating the work equipment. It prevents high pres- sure from being generated when the swing is operated. It also prevents the high LS pressure from the swing circuit from flowing into any other LS circuit when the swing is operated to- gether with the work equipment. (BOOM UP ONLY) Operation 1.
When a pilot pressure BP is OFF. (BOOM OP = 0) a. Pilot pressure BP is OFF, so piston (3) is pushed to the left by spring (2). If the swing is then operated, swing LS pressure P1 passes through swing pool (5) and enters port A . It pushes valve (1) to the left and con- nects ports A and B . Therefore, swing LS pressure P1 flows to LS shuttle valve (8). 2. When pilot pressure BP is ON. (BOOM UP ACTIVED) a. When pilot pressure BP is ON, piston (3) is moved to the right against spring (2) by the BP pressure. It pushes valve (1) to the right and closes the circuit between ports A and B .
As a result, swing LS pressure P1 stops flowing to LS shuttle valve (8), and even if swing LS pressure P1 rises to a high pressure, it does not influence any other LS circuit. 10-70