Komatsu — eebm001902 a3.pdf

STRUCTURE AND FUNCTION CLSS 2-stage safety valve (installed to boom cylinder head) 1. Spring 2. Piston 3. Spring 4. Holder Function The set pressure of the safety valve can be set to two stages and the low pressure setting can be made smaller. Because of this, when dig- ging with boom, even if high pressure is brought to bear on the boom cylinder, it is possible to let the boom escape without operating the control lever. This makes it possible to carry out opera- tions with high efficiency and with little vibration of the chassis. Operation The set pressure of the safety is determined by the load pressure of spring (1). 1. When pilot pressure P is OFF:

high pressure setting (active mode ON) a. Pilot pressure P is OFF, so piston (2) is pushed to the left by spring (3). (Installed load of spring (1) (3)). When this happens, the installed load of spring (1) becomes the maximum, and the set pressure is set to high pressure. In addition, passage B is connected to the drain circuit through passage C and cham- ber D 2. When pilot pressure P is ON: low pressure set- ting (active mode OFF) a. When pilot pressure P is ON, the pilot pres- sure goes to portion A through passage B , and piston (2) acts on the diameter of por- tion A receiving the pressure ( d2 - d1 ). Pis- ton (2) is moved to the right against spring (3) y this pilot pressure.

It moves the full stoke until it contacts holder (4). As a re- sult, spring (1) extends, the installed load becomes the minimum, and the set pres- sure is set to low pressure. In addition, an amount of oil equivalent to the piston stroke passes through passage C and chamber D , and is drained. 10-73