Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the ° F)) ° F)) 3 - 113 rature to go down before startin When removing the oil filler cap, turn i t slowly to release the internal pressure, 1. Set t he work equipment in the po sture shown in the diagram on the r ight, then check the oil level and add oil if necessary. the condition shown in the ngine, run the engine at low 2.

If th e work equipment is not in ram on the right, start the e diag spe lowe and ed, retract the arm and buc ket cylinder rods fully, then r the boom, set the bucket te eth in contact with the ground, stop the engine. in 15 seconds after stopp ing the engine, move each 3. With cont in al rol lever (for work equipmen t and travel) to the full stroke l directions to release the int ernal pressure. right window installed to the 4. Che ck sight gauge (G) from the oper and ator's compartment. The oil l evel should be between the H L lines. NOTICE Do not ad d oil above the H line. This will damage the hydraulic equipment and may cause oil to spurt out.

If oil is added above the H line, stop the engine, w ait for the oil temperature to co ol down, put a container to catch the oil un der drain plug (P) at the bottom of the hydraulic tank, then drain the exces s oil from the drain plug. 5. If th e oil level is below the L line, add oil through oil filler (F) at the t op of the hydraulic tank. REMARK The oil l evel will vary depending upo Accordi ngly, use the following as a g Befor e starting operation: Betwee (Oil t emperature 10 to 30°C (50 t Norm al operation: Around H leve (Oil t emperature 50 to 80°C (122