. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING 3 - 114 Do no t open the r adiator cap unl ess necessary. W hen checking th e coolant, always wait for the e ngine to cool down and c heck the s ub-tank. Immediately after the engine is stopped, the coola nt is at a high te mperatur e and the radiator is under high internal pressure. If the cap is remo ved to check the coolant level i n this condition, there is a hazard of burns. W ait for the temperature to go down , then turn t he cap slowly to release the pre ssure and remov e it carefully. 1. Op or at the left of the machine own in the diagr , and check i f the 2.
-tank (1) (sh am on the rig ht) is between the F ULL and LO W marks. If the c oolant level is low, add coolant to the FULL lev el through the fi ller port of sub-tank (1). Aft er adding coolant, tighten the cap securely. 3. If the sub-tan leakage. After k becomes checking, re empty, there is pair any abnorm probably co ality immediate olant ly. If no abnormalit y is found, c s low, add heck the level of the water in the e same density in ty table in "CLEAN the radiator. If it i COOLANT of th ty in radiator accor ding to the C OOLANT densi INSIDE OF COOLING S YSTEM (PAGE 4-25)", then add . COOLANT to the sub-tank 4.
If th e inside o f sub-tank (1) is dirty and the water level cannot be seen, use t SYSTEM (PA he procedur GE 4-25)". e in "CLEAN INSIDE OF COOLING