. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Engine Oil Pan, Add Oil WARNING engine is stopped and may cause serious burns. Wait for the oil 2. Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe, then remove it. REMARK 3 - 115 emperat mediately temperature to go down b efore performin g this op eration. 1. Open t he engine ho 4. The oil level should be between t he H and L marks on dipstick (G). If the oi l level is bel ow the L mark , add oil through oil f iller port (F). 5.
If the oi l is above th e H line, open drain va lve (P) at th e bottom of the e ngine oil pa n, drain the excess engine oil, then check the e il, the n check the oil l evel again. 6. If oil lev el is correct, securel y tigh ten the o il filler cap a nd close the eng When chec king the oil le vel afte r the e ngine ha s been oper ated, wait for at least 15 minutes a fter stopping the engine before chec I f the mach ine is at an angle, m ake it horizon tal before ch ecking.