Komatsu — LOADING AND UNLOADING WITH TRAILER

. OPERATION TRANSPORTATION LOADING AND UNLOADING WITH TRAILER WARNING Always obey the following when loading or unloading the machine from a trailer. Select firm, level ground when loading or unloading the machine. 3 - 175 Maintain a safe distance from th Always turn the auto-deceleratio If the auto-deceleration switch start moving. Always set the travel speed swit e edge of the road. n switch OFF (cancel). is left ON, the machine may suddenly ch to low speed (Lo), run the engine at low idling, and operate the mac hine slowly when loading or unloading.

In cold areas, carry out the warm ing-up operation thoroughly and make sure that the engine speed is st able before carrying out the loading or unloading operation. Never correct your steering on machine may tip over. the ramps. There is danger that the If necessary, drive off the ramps direction. or back on to the trailer and correct the It is dangerous to use the work equipment for loading and unloading operations. Always use ramps. rate any lever except the travel lever. When on the ramps, do not ope The center of gravity of the ma chine will change suddenly at the joint between the ramps and the trail er, and there is danger of the machine losing its balance.

Travel slowly over this point. If it is necessary to swing the wo rk equipment on the trailer platform, the footing is unstable, so be extre mely careful that the machine does not tip over. If the work equipment is inst alled to the machine, pull the work equipment in, and operate slowl y to prevent the machine from losing its balance. Position a flagman to give gu idance to prevent the machine from sure safety in the operation. coming off the ramps and to en Always observe the following rega rding the ramps and trailer platform. Use ramps with ample width, len gth, thickness, and strength and install them at a maximum slope of 15 °.

When using piled soil, compact the piled soil fully to prevent the slope face from collapsing. Clean the machine tracks and ra mps before starting in order to prevent the machine from slipping on th e ramps. There is danger of the machine slipping if there is water, snow, grease, oil, or ice on the ramp surface. When loading or unloading, alw ays use ramps or a platform. Proceed as