Komatsu — LOADING AND UNLOADING WITH TRAILER

. OPERATION TRANSPORTATION Loading bending. speed monitor (6). 3 - 176 1. Load and unload on firm level Maintain a safe distance from 2. Apply the trailer brakes secure ly, then put blocks (1) under the tires to prevent the trailer from Set left and right ramps equally spaced to the left an d right of center (3) of the trailer. Make angle of installation (4) a maximum of 15°. If the ount under the weight of the ramps bend a large am machine, put blocks under the ramps to prevent them from 3. Turn the travel speed selecto lamp lights up). Press travel speed selecto r switch to low speed travel (Lo r switch (5) to switch the travel speed.

The travel speed (L o, Hi) is displayed on the travel 4. Turn auto-deceleration switch (7) OFF and operate the fuel control dial to set the engine s Each time auto-decelerat switches OFF J ON J OF When auto-deceleration s auto-deceleration monitor ( control dial to set the engine s Each time auto-decelerat peed to low idling. ion switch (7) is pressed, it F in turn. witch (7) is turned OFF, the 8) goes out. switches OFF J ON J OF When auto-deceleration s auto-deceleration monitor ( 5. Turn the swing lock switch ON to apply the swing lock. When the swing lock switch is turned to the ON position, the swing lock monitor (9) light (a): ON position (b): OFF position s up.