. OPERATION TRANSPORTATION OPERATION TRANSPORTATION 3 - 177 6. If t he machine is equip ped with work equipment, s et the w ork equipment at the front, and travel forward to load it ; if it has no work equipment, travel Follow instructions an when traveling in rever 7. Before moving onto the ramps, make sure that the machin e is positioned in a straig ht line with the ramps a the centerline of the machi ne matches that of the trail Align the direction of tra vel with the ramps and tra vel slow Lower the work equipm ent as far as possible with out causing interference. When on the ramps, operate any other lever 8.
When loading or unload ing a machine with the wor k equipment installed, at the point w here the tracks are on bot h the ramps and the ground surface , turn the swing lock switc h OFF, t hen swing the upper structu re slowly 180°. After doing that, drive s lowly in reverse and load t he machine onto the trailer. 9. Turn the swing lock sw itch ON to apply the swing When the swing lock switch is turned to the ON position, the swing lock monitor ( (a): ON position (b): OFF position