. MAINTENANCE MAINTENANCE PROCEDURE Cleaning Outer Element NOTICE 1. Open a door located at the rear left side of the machine, release hooks (2) at 3 locations and then detach cover (3). NOTICE When cleaning the element, do not hit or beat it against anything. 7. Direct dry compressed air (less than 0.2 MPa (2.1 kg/cm 2 , 30.0 PSI)) to the outer element from inside along its folds, then direct it from outside along its folds and again from inside. 1) Replace the outer element which has been cleaned 6 times repeatedly or used throughout a year. Replace the inner element at the same time.
2) Replace both inner and outer elements when the air cleaner clogging monitor (1) lights up soon after 4 - 20 Before and after cleaning the eleme nt, do not leave or keep it in direct sunlight NOTICE Never remove the inner element (6). It will allow dirt to enter and cause failure of the engine. r tool. Do not use a screwdriver or othe 2. Hold the outer element (5), rock it lightly up and down and to the left and right, and rotate pull it out. the element to the left and right to 3. When the outer element (5) has been removed, check that the inner element has not com angle. If is is at an angle, straight. e out of position and is not at an insert your hand and push it in 4.
After removing the outer ele ment (5), cover the inner element (6) with a clean cloth or t entering. ape to prevent dirt or dust from 5. Wipe off or brush off the dirt stuck to cover (3) and the inside of the air cleaner body (7). 6. Remove any dirt or dust that is accumulated to evacuator valve (4) installed to cover (3). ter element even though it has not been cleaned 6 time