. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE has been cleaned. 4 - 21 one seal from the e lement whenev er the element 8. If small hole s or thinner parts ar e found on the element when it is checked the element. by shining a light th rough it after cle aning , replace 9. Remove the cloth or tape coveri ng inne r eleme nt (6). NOTICE lement whose folds or gasket or seal are damaged. Do not use an e lement whose folds o r gasket or seal a re damaged. If the element o r O-ring are cleaned a nd used again aft er they have bee n used for more tha n one year, it will cause problems. Do not use them again. 10.
Check that th ere is no dirt or oil stuck to the sea l portion of the new element or c leaned element. Wip e off any dirt or oil. er element in straight with your hand when installing it to the air cleaner body. 11. Push the out er element in straig ht with your ha nd when installing it to the air cle If the outer e element can lement is held and r ocked l ightly up and d own and to the left and rig ht while pushing it in, the outer be inserted easily. NOTICE he air cleaner element facing in the correct direction.
Be sure to install t he air cleaner element facing i n the cor rect direction Install so that the b ottom of the air cleane r eleme nt cylinde r (face where no hole is drilled) (B), (C) is at cover (3) end . If the direction of installatio n is mistaken, there is danger that it will c ause breakage of the air cleaner e. leaner element or serious damage to the engin