Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 24 8. Replace O-ring (8) of cover (3) with a Whe n inserting the ele ment, if the rubber at th e tip is swollen or the outer element is not pushed in straight, and cover ( 3) is assembled by force to hook (2), there is da nger that the hook and be damaged, so be carefu 9. I nstall cover (3) as follows. (3) with the element. of hook (2) to the protruding part of the air y and lock it in position.

1) Align cover 2) Hook the tip cleaner bod 3) Always insta the ground ( 4) When cove between the If it is too lar 1) Align cover 2) Hook the tip of hook (2) t o the p y and lock it in positio ll cover (3) so that the evacuator (4) is facing A). 4) When cove r (3) is installed, ch eck that the clearance air cleaner body and cover (3) is no t too large. ge, install again. 10. Replace seal (9 ) on the cover (3) with a new