. MAINTENANCE MAINTENANCE PROCEDURE Replacing Element 1. Open a door located at the rear left side of the machine, release hooks (2) at 3 locations and then detach cover (3). and down and to and is not at an and push it in NOTICE of the air cleaner 4 - 23 2. Hold the outer element (5), rock it lightly up a the left and righ t, and rotate the element to th pull it out. Do not remove inner element (6) when doing 3. When the outer element (5) has been remove inner element angle. If is is straight. has not come out of position 4. Wipe off or bru sh off the dirt stuck to cover (3) the air cleaner 5.
Remove any di rt or dust that is accumulated to (4) installed to NOTICE The inner element must not be cleaned and used ag ain. When replacing the outer element, repl ace the inner element at the same time. If the inner elemen t is not installed properly and the o uter element and cover areinstalled, there is d anger that the outer element will be damaged. The seal portion o n imitation parts lacks precision, a nd allows the entry of dust, which leads to d amage of the engine. Do not use such imitation parts. 6. Remove inner element (6), then quickly instal l the new inner element. es not move. h your hand when installing it to the air cleaner body.
Insert the inner element securely so that it do 7. Push the new outer element (5) in straight wit h your hand when installing it to the air If the element is held and rocked lightly up and down and to the left and right while pus hing it in, the element can be inserted eas ily. Be sure to install the air cleaner element facing in the c Install so that the bott om of the air cleaner element cylin hole is drilled) (B), (C ) is at cover (3) end. If the directio mistaken, there is da element or serious da